Repair your machine guide

Video-tutorials to perform the correct maintenance and repair your machine

Procedures to follow to repair your machine

1-The control panel does not light up or there is no activity:

Checks to follow

If the machine is connected:

Check that the machine is connected to the power outlet.

Pin status:

Check the good condition of the plug, cable, socket and fuses.

Front switch (includes video):

Check the correct operation of the front switch. In this case you can check the support video. In this case you can check the support video.

Input fuses (includes video):

Check the input fuses. In this case you can check the support video.

2-Insufficient or very slow vacuum level:

Checks to follow

Front switch (includes video):

Check the Vacuum program configuration and set it.

Check the oil level and condition (includes video):

Check the oil level and condition.

Oil outlet filter:

Check the oil outlet filter that is not saturated (replace it).

Silicone lip profile (includes video):

Check / replace the silicon lid gasket (ref. ZT0320226).

Control board sensor:

Verify the correct operation of the control board sensor (ref. ZT0232005).

Vacuum leaks (includes video):

Comprobar que no existan fugas de vacío (ref. ZT0280038).

3-Incorrect bag sealing:

Checks to follow

Sealing program and adjust it (includes video):

Check the setting of the sealing program and adjust it.

Expand Sealing wires (includes video):

Verify the condition of the sealing wires (ref. ZT030S000) and of the teflon tape (ref. V0367).

Expand Silicone of the upper sealing bar (includes video):

Verify the condition of the silicone of the upper sealing bar.

Expand Contact between the sealing bar and the lifting pistons:

Verify a good contact between the sealing bar and the lifting pistons.

Expand Component verification test (includes video):

Carry out a component verification test.

4-The lid do not open automatically:

Checks to follow

Verify the gas spring (includes video):

Verify the gas spring (replace it).

Expand Micro switch on the lid:

Verify the correct operation of the micro switch on the lid (adjust).

Expand Verify the valves unit (includes video):

Verify the valves unit.

5-Fl appears on the screen:

Checks to follow

Micro switch on the lid

Verify and adjust the micro switch on the lid.

Expand Vacuum pump (includes video):

Verify the correct vacuum pump operation.

6-F2 appears on the screen:

Checks to follow

Checks the lid:

Check if the lid opens and restart the machine.

Expand Cycle repetition (includes video):

Inform about the cycle repetition.

7-"- - -" appears on the screen:

Checks to follow

Verify that the lid opens (includes video):

Verify that the lid opens at the cycle end.

8-White smoke comes out of the vacuum pump:

Checks to follow

Check / change oil (includes video):

Check / change oil outlet exhaust filter.

9- Fix vacuum pump:

Checks to follow

Check / change oil (includes video):

Steps to follow to repair the machine: